All Posts / 2

fix gatsby build getting stuck at source and transform nodes

Sometimes, gatsby build process is stuck at source and transform nodes phase or may be at createPages etc. There is a very weird fix to it. Trust me, this is ..

fix error: 413 Request Entity Too Large on deploy with caprover

When you are deploying a tar file with large size, you will see this error message. This is caused due to the nginx.conf which sets default max file size limit ..

How to fix frequent nodemon error: address in use

nodemon throws 'address already in use' after few file changes/restarts. Simple solution is to kill the port with kill -9 3000 (use the appr. port numbe..

Published a fully opiniated nextjs starter

It is a basic and fully opiniated template that consists of the essential elements that are required to start building a NextJs application. I end up doing the ..

How I saved $400/year by switching from Bluehost VPS to Netlify + Migadu

I’ve been using Bluehost VPS for over 5 years. I purchased the standard plan for a year which was $24.99/month and then I kept on renewing it for 3 months at ..

How to migrate wordpress blog posts to gatsby

Recently, mHotspot and blog were switched from two seperate wordpress installations to gatsby. The process, however, was easier than it should be. For mHotspot,..

Set LDAC as default bluetooth codec in Android Oreo

I enabled and chose LDAC as bluetooth code from developer settings menu. But after disconnecting and reconnecting my phone, the codec switches back to aptX. The..